Before I turned on the jack, my friend stood back. We thought all hell would break loose as the jack hammered the old floor into rubble. We thought the very foundation would shake and we would have trouble staying upright. Well, it turns out to be quite a bit mellower then that. It may have been the fact that the concrete floor was 4-5″ thick, it may have been that there was more Portland cement in the original mix then a sane man would specify. Whatever the reason, the floor barely budged. After a few hours of trial and error, I started to get the hang of it, with the last hour cruising by. Needless to say, it was not a walk in the park, but it was better then just using an 8LB hammer like the first time (I felt like I was going to die from strain.) After 6 hours we had a 12′ diameter hole. That was enough for one day.

The next day my girlfriend and I laid down some foam (for a little insulation) and 17 bags of sand mix cement. That’s over 1,200lbs of concrete. It took us 6.5 hours. And man is laying concrete hard (especially when you care about how flat it is. One thing I learned was that sand mix can be easily smoothed out when dry, so about 1.5 hours of back-breaking work perfecting the skimming was wasted time. Live and learn.

Three quick advantages with using dimmer switches:

• Reduced Energy Consumption, Dim your lights by quarter & save up to 20 percent Dim by half and save up to 40 percent.
• Increased Bulb Life, If you are dimming the light by just 10 percent it more than doubles the life of the bulb.
• Mood, A softer light is more comforting and sets a relaxing atmosphere.

We can install many different kinds of dimmer light switches. 3-way dimmable light switches are also available.

Call Stafford for more information on going green in your home.

Kris Thompson
Stafford Home Service
Office:   952.927.7194
Fax:      952.927.7192
Direct:   612.328.3989

1. If your home has a outdated circuit breaker panel or fuse box (usually located in your basement) –e.g. Federal Pacific circuit breaker panel.
   1. How does one identify an outdated panel? –Because there are so many brands/styles its probably best to contact us for a evaluation.
2. If your circuit breaker panel or fuse box does not have a main fused shut off switch.
3. If you are planning significant lifestyle changes in your home that will put added demand to your electrical system.
4. If you have a 60 amp service. Typically you can have only one 220 volt appliance on a 60 amp service. A demand load calculation should be used to determine this.
   1. How can someone easily identify their “amp service”? –Typically there is a listed label on the  panel
5. If your main fuses blow or main circuit breaker shuts off.
6. If you are planning on having your wires buried from your local power company you will need to change your meter socket and usually this is a good time to upgrade your circuit breaker panel or fuse box to a more modern and safer system.If you do not have adequate room for additional circuits, Such as adding air conditioning, electric water heaters, electric clothes dryers, electric heat, hot tubs, ect.

Kris Thompson
Stafford Home Service
Office:   952.927.7194
Fax:      952.927.7192
Direct:   612.328.3989

How to control all of this you ask? Well, my dear, with my iPhone of course! Yes, I said my iPhone. Or maybe a iPod touch if I want to let visitors have fun too. The Buletooth controllers on the PS3 and the Wii only five bout 30′ of distance so they will ne installing a Bluetooth repeater in the kitchen (the basement media room is abutted to the stair, so that is not an issue. The Wii controllers also use a control bar which emits light, so another remote bar will be installed in the 1st floor. Sick, isn’t it? One can walk from the basement to the 1st floor, Guitar Hero “guitar” in hand, jamming all the time. Now that’s class my friends. Or some kind of digital excess yet to be named.

One great advantage to this madness (or brilliance, depending on your Luddite or Jobs tendencies) is that fan noise is greatly reduced or eliminated. The PS3 is still screaming out billions of cycles and driving it’s fans like rented mules, but it is safely ensconced in a separate room, in a tidy rack. Ahhh, peace and quiet. Now, when I am watching a classic film, with plenty of moody silence, like The Third Man I won’t be distracted by the steady roar of the PS3′s insane fans.

Another advantage is the savings of not having to have duplicate hardware;  in space, cash, and energy (I guess that’s kind of a Geen Renovation thing as well. Nice!)

Stay tuned for updates and photos.

One thing he explained is how he was going to mount the basement ducts a couple inches lower then I had first assumed. He said these critical few inches would make the ducts that much more quiet, as they would better isolate the vibrations of ducts and movement of floor. Brilliant! He was also very concerned with the placement of vents for cosmetic and functional reasons. He explained many situations where ducts would be a problem. If it were up to me I would have ended up choosing locations that would have essentially heated the outside and the furniture. Nothing like a great HVAC contractor to save the day!

Next was the Stafford Electric team. Kris came in on Thursday and walked through the entire space with me and Jason from Stinson Builders. Even though we had blueprints (do they still call them that?) and had previously discussed many of the options, Kris insisted on walking through every detail again and making sure we were all on the same page and that we were moving forward in the best possible way. As we walked through, Kris proposed new options that were better then the old, like recessed lighting in the basement guest bedroom and workout/craft area. Jason and Kris pointed out that those spaces would benefit by having finished ceilings. I am so happy that I began this process with Stinson Builders; Jason’s subcontractors are friendly, committed to the job and my satisfaction, and unbelievably helpful.

One exciting idea Kris cooked up, for the rest of the basement was to put in conduit and cage lights, in between the floor rafters Something like this (but cheaper, more industrial, and steel instead of brass):

This is perfect for the industrial look I am going for. I had the ceiling spray painted with BIN paint which has shellac in it (the only thing sure to lock out the lingering dog and cigarette smoke odors.) which I tinted a light blue-grey. I think it’s going to look great. Thanks Kris!

As we walked around the space I got a glimpse at the complexity of a good electrician‘s job. The melding of practicality, ease of use, efficiency, code compliancy, cosmetics and the like creates for a difficult terrain. Make sure you have a great firm like Stafford Home Services’ electric department to navigate the landscape or you may find yourself pulling things out later (at much higher expense), and being disappointed with the results.

One simple, electrical Green Renovation solution that Stafford is installing is dimmer switches at all locations. (there are even 3-way, adjustable light switches!) Did you know light dimmer switches were Green? Well they are. Kris and Dan told me about a Green Home workshop they attended that trained electricians and home services on going Green. Evidently the human eye only needs about 80% of a room’s full lighting. They were shown a demo and said they could not tell the difference, once their eyes adjusted. I assume that’s a 20% savings in lighting bills! Nice!

As we walked through the space, Kris stopped one of his electricians and had him move a flush, floor-mounted electrical outlet. It was just a rotation of a outlet that already had been installed. The electrician did not look happy but Kris insisted. I went back later and saw why: to rotate the box, there had to be new framing to support each unit. To think, here they are making more work for themselves, work that I would not have thought of until another contractor was done and gone, and they doing it just to make sure the aesthetics are just right. That’s the kind of electrician I want!

All said and done, this has been a good week. Stay tuned next week for updates on the Green electrical and Green HVAC installations.

-M

• Emily Anleu (my wonderful girlfriend and biggest helper ever!)
• Mike Livingston
• Jeff Klug
• Michael Parker
• Clint
• Eric Hall (of Avatar Training Studio)
• Nick Buettner
• Molly Green
• Blake Darsow
• Suzanne Pfeiffer

I am so thankful for all of your help!!!

It was unbelievably hard work. The previous builder must have had stock in a nail company because I have never seen so many nails used in all my life. It was ridiculous.

This is what we did:

• Removed basement walls including a 20″ long organization center and a cedar closet. Down to the concrete block.
• Removed basement ceiling
• Removed all flooring on 1st floor except original oak (in bathroom and hallway)
• Removed ceiling in kitchen and back addition.
• Removed walls in Kitchen and back addition.
• Removed rear addition walls.
• Removed rear addition bathroom.
• Removed rear addition closet.
• Moved Rear addition windows, removed one.
• Removed kitchen cabinets and sink
• Removed carpeting from front addition.
• Removed carpeting from rear addition.
• removed tile from kitchen.
• removed Kitchen pantry.
• Removed 3rd bedroom closet.
• Removed Stairway walls.
• Removed plumbing from rear bathroom.
• Removed sewer line, all the way to the main stack.
• Removed Stairway.
• Removed chimney.